Table of Contents
Advertisement
5.
Press (B).
This causes the hours digits to flash.
Hours
6.
Rotate the crown to change the hour
setting.
If you are using 12-hour timekeeping,
●
the time setting is indicated as [A] (a.m.)
or [P] (p.m.).
7.
Push the crown back in to complete the
setting operation.
Note
If you do not perform any operation for
●
about three minutes while in the Alarm
mode, the watch automatically returns
to the Timekeeping Mode.
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
Watch Operation Guide 5682
Enabling the Hourly Time
Signal
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (A) or (C) to display the hourly time
signal screen ([SIG]).
3.
Press (D) to toggle the hourly time signal
between enabled and disabled.
[SIG] (hourly time signal) is shown on
●
the display while the hourly time signal
is enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Hourly time signal
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (A) and (C) to scroll through alarm
numbers ([AL1] to [AL5]) and the hourly
time signal ([SIG]) screens until the one
whose setting you want to change is
displayed.
Alarm number or hourly time signal
3.
Press (D) to turn off the displayed alarm or
the hourly time signal.
Each press of (D) toggles between ON
●
and OFF.
Turning off all alarms causes [ALM]
●
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
Note
If [ALM] (alarm) is still displayed, it
●
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
17
Advertisement
Table of Contents
