Table of Contents
Advertisement
The output terminal OUTPUT TAPE (15) must be connected to the recording input of the
TAPE output
taping device that has been hooked up with its outputs to the INPUT TAPE (16).
The tape out terminal provides the signal of the selected input CD, TUNER, AUX1 or AUX2
but not the signals from the inputs TAPE and SURROUND.
Volume and tone control have no influence to the TAPE OUT signal.
For additional connection of power amps or active loudspeakers the 051 provides two pairs
PREAMP outputs
of output jacks: OUTPUT BALANCED (30) and OUTPUT UNBAL(anced) (31).
These outputs provides the signal of the selected input CD, TUNER, AUX1, AUX2 or TAPE
but not the signals of the input SURROUND.
The pinning of the balanced output is: PIN1=GND, PIN2=NEG, PIN3=POS.
Volume and tone control have no influence to the TAPE OUT signal.
Connecting DC OUT (25) to the corresponding DC IN-jack of another BURMESTER-unit
REMOTE
offers to switch on or off this other unit simultaneous by the 032. In this case, 032 has the
master function.
Connecting DC IN (27) to the corresponding DC OUT-jack of another BURMESTER-unit
offers to switch on or off the 032 simultaneous by the other unit. In this case, 032 has the
slave function.
To the BURmester-LINK interface plugs (26), (29) a computer system like PC,
BURLINK
CRESTRON
system allows a comfortable control of your hifi system using an individual programmable
touch panel for example. With the LEDs beside the plugs named T and R (Transmit and
Receive) you can check whether data exchange is working.
®
, Nevo e.g. can be connected to the integrated amplifier 032. The computer
4
Advertisement
Table of Contents
