Push Button Transmitter - Bellman & Symfon Visit BE1411 Installer's Manual

VISIT TRANSMITTERS
Visit push button transmitter
Buttons and connections
Status LED Front button Radio key switches
Front cover
Technical specifications
In the box Dimensions and weight
BE1420 Visit push button transmitter Height: 66 mm, 2.6"
 
with pre-mounted PX28G/PX28M
Width: 48 mm, 1.9"

6V alkaline battery
Depth: 23 mm, 0.9"
Lanyard with safety clasp 

Adhesive tape, screws and plugs
 Weight: 50 g, 1.8 oz. incl. battery

Power and battery Activation
Via the front button
 Battery type 
1 6 V PX28G/PX28M alkaline or

Environment
1 6 V PX28L lithium

For indoor use and outdoor use

Power consumption

in a protected location. Will not
Active < 35 mA
withstand water or rain. (IP42)
Idle position < 0.05 μA
Operating temperature

-10° to 40° C, 14° to 104° F
Operation time

Alkaline battery ~ 2 years Relative humidity

Lithium battery ~ 5 years 15% to 90%, non-condensing
13
Signal switches Hole for lanyard
Pre-mounted battery Adhesive tape 2 hole markings

Frequency and coverage
Frequency: 315 MHz, 433.92 MHz or

868.3 MHz, depending on region
Coverage by region:

315 MHz: Up to 50 m (164 ft)
433 MHz: 30 – 80 m (98 - 260 ft)
868 MHz: 50 – 250 m (55 - 273 yd)
Coverage depends on the radio
frequency, building's characteristics
and the combination of transmitters
and receivers.
Maintenance and cleaning
Maintenance free

Clean with a dry cloth
Do not use household cleaners,

aerosol sprays, solvents, alcohol,
ammonia or abrasives
Using it as a caller button
The transmitter can be worn around your neck and
be used as a wireless caller button.
Here is how you use it:
A
1 Attach the lanyard to the transmitter.
2 Hang the transmitter around your neck.
Using it as a doorbell
The transmitter can also be used as a wireless doorbell. Here is how you set it up:
Mounting with screws
1 Carefully remove the transmitter front cover and make two holes on the markings.
2 Fix the unit to the wall using the supplied screws and put the cover back on.
1
Mounting with adhesive tape
1 Attach the adhesive tape to the back of the transmitter.
Clean the wall with the wet wipe and remove the protective film from the tape.
2 Mount the unit in a weather protected area by the front door.
1
www.bellman.com
Bellman Visit 868 Pushbutton transmitter
Model: BE1420
Frequency 868,3 MHz
Battery: 1 x 6V
Made in P.R.C. by Bellman & Symfon AB, Sweden
BE1420
1 2
B
2
2
14