Pager Receiver - Bellman & Symfon Visit BE1411 Installer's Manual

VISIT RECEIVERS
Visit pager receiver
Buttons and controls
Visit LEDs Front label
Function button Battery LED
Technical specifications
In the box Dimensions and weight
BE1470 Visit pager receiver Height: 86 mm, 3.4"
 
Width: 57 mm, 2.2"

Safety cord with clip

Depth: 29 mm, 1.1"

Extra front label

Weight: 70 g, 2.5 oz. incl. battery

Power and battery Visit LEDs
Mains power
 The Visit LEDs normally indicate
7.5 V DC 1500 mA via the charger the following:
Orange LED, pacifier symbol

Battery power

The baby monitor is activated
1.5 V AAA alkaline or
Green LED, door symbol
1.2 V AAA NiMH rechargeable battery 
The door transmitter is activated
Operation time
 Yellow LED, telephone symbol

Alkaline battery: 2 – 3 weeks
The phone transmitter is activated
NiMH battery: ~1 week
Red LED, fire symbol

The smoke alarm is activated
Power consumption

Active: 220 mA
Orange and red LEDs blink alternately

Idle position: ≤1 mA The CO alarm is activated
53
Belt clip Battery cover Battery eject Battery compartment
Optional safety cord with clip
Environment
For indoor use only

Operating temperature
0° to 35° C, 32° to 95° F
 Relative humidity
15% to 90%, non-condensing
Frequency and coverage
 Frequency: 315 MHz, 433.92 MHz or
868.3 MHz, depending on region
Coverage by region:

315 MHz: Up to 50 m (164 ft)
433 MHz: 30 – 80 m (98 - 260 ft)
868 MHz: 50 – 250 m (55 - 273 yd)
Coverage depends on the radio
frequency, building's characteristics
and the combination of transmitters
and receivers.
Accessories
BE1260 Pager charger

BE1270 Bed shaker

Getting started
1 Open the battery cover, fit the battery and close the cover again.
Attach the pager to your belt using the belt clip. For extra security, use the supplied safety cord.
2 To test the radio link you need a Visit transmitter. Press the test button/s on the transmitter.
3 The pager starts to vibrate and lights up a Visit LED. If a bed shaker is connected during charging, it will vibrate.
If nothing happens, see Troubleshooting.
1
Default signal pattern
When a transmitter is activated, the pager lights up an LED and starts to vibrate with a certain pace. This is called signal
pattern. The transmitters determine the pattern, and the default is as follows:
Activated transmitter Pager LED
Door transmitter Green

Push button transmitter Green

 Telephone transmitter Yellow
Baby monitor Orange

Smoke alarm Red

 CO alarm Orange and red
Changing the signal pattern
The signal pattern can only be changed on the transmitters. See Changing the signal pattern for the relevant transmitter.
Changing the front label
If you want to use Visit for other purposes, the pager front label can be replaced with a customized one. Here is how it's done:
Open the battery cover, replace the original label with the supplied extra label and close the cover again.

Replacing the battery
When the battery LED starts to blink in yellow, the battery is nearly depleted. Here is how you replace it:
Open the battery cover and press the battery eject button to remove the old battery. Insert a 1.5 V AAA alkaline battery

or a 1.2 V AAA NiMH rechargeable battery if you are using the BE1260 charger accessory.
BE1470
2 3
Pager / bed shaker vibration
Slow
Slow
Medium
Fast
Long
Long
54