Bellman & Symfon Visit BE1411 Installer's Manual page 5

VISIT TRANSMITTERS
Visit door transmitter
Installation – intercom and electronic doorbell
1 Remove the protective film from the external microphone (sold separately) and attach it to the intercom's speaker.
Connect it to the door transmitter.
2 Pull the battery tab to start the transmitter.
Clean the wall with the wet wipe and remove the protective film from the Velcro.
3 Mount the door transmitter to the left of the doorbell's sound source, as close as possible.
Note: The intercom and doorbell must be at least 25 cm 10" apart to avoid sound interference.
1 2
Ext. mic.
(sold separately)
Installation – intercom and mechanical doorbell
If you have an intercom and a mechanical doorbell, you may need two door transmitters, i.e. one for each sound source.
1
Pull the battery tab to start each door transmitter.
Clean the wall surfaces with the wet wipe and remove the protective films from the Velcro.
2
Mount one of the door transmitters to the left of the doorbell and the other to the left of the intercom's speaker, as close
to the sound sources as possible.
1
Max 3 cm, 1.2"
7
3
Max 3 cm, 1.2"
Electronic
doorbell
2
Max 3 cm, 1.2"
Mechanical
doorbell
Installation – hardwiring your doorbell
1 Pull the battery tab to start the transmitter.
Within 2 min, press the lower button 10 times to turn off the internal microphone. The LEDs will blink 3 times to confirm.
2 Remove the front cover to access the screw terminal. There are 3 connection points:
Use 1 and 2 to connect an active switch, like a relay with current (2–30VDC, polarity independent

or 2–24VAC, 5 - 150Hz).
Use 2 and 3 to connect a passive switch, like a push button.

3 Put the front cover back, remove the protective film from the Velcro and mount the door transmitter on the wall.
1
10
Ext. trig
Ext. trig
Using electromagnetic detection
The door transmitter can be set to detect electromagnetic fields emitted by electromechanical doorbells.
Here is how it's done:
Activating electromagnetic detection: Move the 4th signal-switch to the up (on position).

Deactivating electromagnetic detection: Move the 4th signal-switch to the down (off position).

BE1411
1 2
2 3
3
On
8