Wrist Receiver - Bellman & Symfon Visit BE1411 Installer's Manual

VISIT RECEIVERS
Visit wrist receiver
Buttons and controls
Silicone wrist band Visit LEDs Battery LED
Function button Charger
Technical specifications
In the box Dimensions and weight
BE1560 Visit wrist receiver

Height

BE1570 Charger

Width

Elastic wrist band

 Depth
Power supply

Weight 30 g, 1.1 oz.

Power and battery Visit LEDS
The Visit LEDs normally indicate
 Mains power: 7.5 V DC/1500 mA
the following:
Power consumption
 Orange LED, pacifier symbol

Receiver: Active: 100 mA, Idle: 3 mA
The baby monitor is activated
Charger: Active: 650 mA, Idle: 70 mA
 Green LED, door symbol
The door transmitter is activated
Battery power

Yellow LED, telephone symbol

Receiver: 1 1.2 V V40H rechargeable

The phone transmitter is activated
Charger: 4 1.2 V NiMH rechargeable

Red LED, fire symbol

The smoke alarm is activated
Operating and charging time

Receiver: ~30 h, Charging time: ~10 h  Orange and red LEDs blink alternately
Charger: Battery charging time: ~24 h The CO alarm is activated
57
3.5 mm bed shaker input BE1270 bed shaker
Bed shaker
Mains LED test button Charging LED Power supply
Environment
Receiver Charger For indoor use only

Operating temperature
49 mm, 1.9" 100 mm, 3.9"
0° to 35° C, 32° to 95° F
38 mm, 1.5" 95 mm, 3.7"
Relative humidity

12 mm, 0.5" 117 mm, 4.6"
15% to 90%, non-condensing
300 g, 10.6 oz.
Frequency and coverage
 Frequency: 868.3 MHz
Coverage:

50 – 250 m (55 - 273 yd)
Coverage depends on the
radio frequency, building's
characteristics and the
combination of transmitters
and receivers.
Accessories
BE1270 Bed shaker

Getting started
1 Pull the battery tab on the charger and connect the power supply to the mains outlet. The mains LED lights up in green.
Place the wrist receiver in the charger and charge it for at least 2 hours. The charging LED is green during charging.
2 To test the radio link you need a Visit transmitter. Press the test button/s on the transmitter.
3 The receiver starts to vibrate and lights up a Visit LED. If a bed shaker is connected during charging, it will vibrate.
If nothing happens, see Troubleshooting.
1
"click"
Default signal pattern
When a transmitter is activated, the wrist receiver lights up an LED and starts to vibrate with a certain pace. This is called
signal pattern. The transmitters determine the pattern, and the default is as follows:
Activated transmitter Wrist receiver LED
Door transmitter Green

Push button transmitter Green

 Telephone transmitter Yellow
Baby monitor Orange

Smoke alarm Red

CO alarm Orange and red

Changing the signal pattern
The signal pattern can only be changed on the transmitters. See Changing the signal pattern for the relevant transmitter.
LED indications
When the wrist receiver battery is nearly depleted, the battery LED starts to blink in yellow. The charging time is up to 8 h.
The charger is equipped with a battery backup and the charger LEDs indicate the following:
LED Indication Status
Charging LED Green light The receiver battery is being charged.
Mains LED Green light The charger is powered by mains voltage.
Mains LED Green blinks The charger is powered by the battery backup.
BE8102
2 3
Wrist receiver / bed shaker vibration
Slow
Slow
Medium
Fast
Long
Long
58