Table of Contents
Advertisement
VISIT RECEIVERS
Visit wrist receiver
Buttons and controls
Silicone wrist band
Visit LEDs
Battery LED
Function button
Charger
Technical specifications
In the box
Dimensions and weight
BE1560 Visit wrist receiver
Height
BE1570 Charger
Width
Elastic wrist band
Depth
Power supply
Weight 27 g
Power and battery
Visit LEDS
Mains power: 7.5 V DC/1500 mA
The Visit LEDs normally indicates
the following:
Power consumption
Orange LED, pacifier symbol
Receiver: Active: 100 mA, Idle: 3 mA
The baby monitor is activated
Charger: Active: 650 mA, Idle: 70 mA
Green LED, door symbol
Battery power
The door transmitter is activated
Receiver: 1 x 1.2 V V40H rechargeable
Charger: 4 x 1.2 V NiMH rechargeable
Yellow LED, telephone symbol
The phone transmitter is activated
Operating and charging time
Receiver: ~30 h, Charging time: ~8 h
Red LED, fire symbol
Charger: Battery charging time: ~24 h
The smoke alarm is activated
39
3.5 mm bed shaker input
BE1270 bed shaker
Bed shaker
Mains LED
test button
Charging LED
Environment
Receiver
Charger
For indoor use only
Operating temperature
49 mm
100 mm
15° to 35° C, 59° to 95° F
38 mm
95 mm
12 mm
117 mm
Relative humidity
185 g
5% to 95%, non-condensing
Frequency and coverage
Radio frequency
314.91 MHz, 433.92 MHz or 868.30
MHz, depending on the region
Coverage
50 – 250 m, 55 - 273 yd. depending
on the radio frequency and the
characteristics of the building
Accessories
BE1270 Bed shaker
BE9086 External trigger cable
Getting started
1
Pull the battery tab on the charger and connect the power supply to the mains outlet. The mains LED lights up in green.
Place the wrist receiver in the charger and charge it for at least 2 hours. The charging LED is green during charging.
2
To test the radio link you need a Visit transmitter. Press the test button/s on the transmitter.
3
The receiver starts to vibrate and lights up a Visit LED. If a bed shaker is connected during charging, it will vibrate.
If nothing happens, see Troubleshooting.
1
"click"
Default signal pattern
Power supply
When a transmitter is activated, the wrist receiver lights up a LED and starts to vibrate with a certain pace. This is called
signal pattern. The transmitters determine the pattern, and the default is as follows:
Activated transmitter
Door transmitter
Push button transmitter
Telephone transmitter
Baby monitor
Smoke alarm
Changing the signal pattern
The signal pattern can only be changed on the transmitters. See Changing the signal pattern for the relevant transmitter.
LED indications
When the wrist receiver battery is nearly depleted, the battery LED starts to blink in yellow. The charging time is up to 8 h.
The charger is equipped with a battery backup and the charger LEDs indicate the following:
LED
Charging LED
Mains LED
Mains LED
2
Wrist receiver LED
Wrist receiver / bed shaker vibration
Green
Slow
Green
Slow
Yellow
Medium
Orange
Fast
Red
Long
Indication
Status
Green light
The receiver battery is being charged.
Green light
The charger is powered by mains voltage.
Green blinks
The charger is powered by the battery backup.
BE8102
3
40
Advertisement
Table of Contents
