To Set Automatic Send After Select; To Set A Different Channel Of The Indoor Unit Infrared Signal Receiver - Daikin FTXJ20A2V1BW User Reference Manual

4.5.4 To set automatic send after select

4.5.5 To set a different channel of the indoor unit infrared signal receiver

FTXJ-A(W)(S)(B)
Daikin room air conditioner
4P518786-9H – 2021.12
1 In the wireless remote control setting menu, navigate to the automatic send
after select setting using
Minimum: 0 seconds
2 Change the setting using
3 seconds. The value changes by 1 second with each step.
In case 2 indoor units are installed in 1 room, you can change the channel for the
infrared signal receiver on the indoor unit to avoid the wireless remote control
signal confusion.
Prerequisite: Perform the following setting for only 1 of the units.
1 In the wireless remote control settings menu, navigate to the channel
selection setting using
2 Change the setting to channel 2 using
Channel 1
3 Confirm your selection using
Result: The Daikin eye will start to blink.
4 Press the indoor unit ON/OFF switch while the Daikin eye is blinking.
a ON/OFF switch
INFORMATION
If the setting could NOT be completed while the Daikin eye was blinking, repeat the
setting process from the beginning.
and .
3
0
and . Minimum is 0 seconds and maximum is
and .
and
.
a
4 Before operation
|
Maximum: 3 seconds
3
0
.
Channel 2
User reference guide
29