Daikin FTXJ20A2V1BW User Reference Manual page 49

When priority room setting is active
FTXJ-A(W)(S)(B)
Daikin room air conditioner
4P518786-9H – 2021.12
Exceptions: If the first unit that was turned on is set to fan only, and then in the
other room heating mode is set, priority will be given to the unit set to the heating
mode. The first unit will go in standby and the Daikin eye will flash.
INFORMATION
▪
The cooling, drying, and fan only operation modes may be used at the same time.
▪
The automatic operation mode automatically selects cooling or heating,
depending on the room temperature and the temperature setting. If the
automatic operation mode is selected for all units, all units will operate in the
mode of the first unit that was turned on.
Priority when using Outdoor unit quiet operation
Refer to "5.9 Outdoor unit quiet
1 Set Outdoor unit quiet operation in all rooms using the wireless remote
controls of the units.
2 To cancel Outdoor unit quiet operation, you may stop operation in 1 room
using a wireless remote control.
Result: Operation will stop in all rooms.
other wireless remote controls.
3 To remove the symbol from the other wireless remote controls, stop Outdoor
unit quiet operation in all rooms separately.
Result: The symbol will disappear.
You can select a different operation mode for each room.
Example: Room A has priority, cooling operation mode is selected.
Operation mode in room B, C, D Status of room B, C and D
Cooling, drying or fan only
Heating
Automatic
Priority when using Powerful operation
Example: Room A has priority. Rooms B, C and D are operating.
1 Set Powerful operation in room A.
Result: Capacity in room A is increased. Cooling or heating efficiency in rooms B, C
and D may be slightly reduced.
Priority when using Outdoor unit quiet operation
Example: Room A has priority.
1 Set Outdoor unit quiet operation on one unit.
Result: All units enter the Outdoor unit quiet operation mode at once.
4
operation" [ 41].
will remain on the display of the
Current operation mode maintained
Standby mode. Operation resumes when room
A stops operating.
If cooling operation continues. If heating units
enter standby mode. Operation resumes when
room A stops operating.
5 Operation
|
User reference guide
49