Table of Contents
Advertisement
Auto-flip function on channel 6
I5
SW4/5
+100% +100%
I6
SW6/7
+100%
+125%
I7
free
+100% +100%
I8
free
+100% +100%
I9
free
+100% +100%
trv
1
0%
2
0%
3
0%
4
0%
5
0%
6
+125%
7
8
0%
0%
9
0%
10
0%
11
0%
12
0%
+
+
Switching the FPV transmitter channel
I5
SW4/5
+100% +100%
I6
SW6/7
+100%
+100%
I7
free
+100% +100%
I8
free
+100% +100%
I9
free
+100% +100%
trv
I5
SW4/5
+100% +100%
I6
SW6/7
+100%
+100%
I7
free
+100% +100%
I8
free
+100% +100%
I9
free
+100% +100%
trv
1
0%
2
0%
3
0%
4
0%
5
–100%
6
0%
7
0%
8
0%
9
0%
10
0%
11
0%
12
0%
+
+
S1038_Q06_V1.0pn_en
If the copter is in attitude mode, the automatic flip function can eas-
ily trigger a flip of the copter.
The auto-flip function is activated via a key switch assigned to chan-
nel 6. This has to be programmed on channel 6 in the "Control set-
ting" menu of the transmitter and then, with the button held down,
+
the asymmetrical travel must be set to +125%.
If this button is pressed, the servo position of channel 6 exceeds the
value of 111% and the autoflip function is thus "armed" for 5 sec-
onds. As soon as the roll or pitch control stick is moved over more
than 50% of the stick travel within this time, the copter will automat-
ically flip in that direction.
Note
After the flip, position deviations in the range <10 ° are possible.
If the Attitude mode and the motor stop function are active, with
each switching pulse of + +100% on channel 6, the transmission
channel of the FPV transmitter can be switched in rotation.
+
Only with optional GPS module No. S8437
Autopilot mode
The combination of a -100% control signal on channel 5 and 0% on
channel 6 switches to autopilot mode. Neutral stick position means
GPS position and altitude hold.
If you start in autopilot mode, the height is maintained at the middle
+
of the stick (0%).
If you start in Rate or Attitude mode and then switch to the autopi-
lot mode, the throttle position when switching the mode is the stick
position at which the altitude is maintained.
When starting in autopilot mode with a throttle position above the
middle of the stick travel (0%), the copter automatically raises to a
height of approx. 1m so that it can hold the position.
In autopilot mode, an electronic grid is set at 500 m distance and the
max. altitude. Upon reaching the limits, a corresponding warning
message is transmitted to the transmitter.
Note
An additional value of more than +50% on channel 7 switches to
"Carefree autopilot mode".
13 / 34
Advertisement
Table of Contents
