Related Manuals for Avigilon NVR5-RAM-16GB-A
Summary of Contents for Avigilon NVR5-RAM-16GB-A
- Page 1 Avigilon NVR5 16 GB RAM Kit Installation Guide Installation Guide NVR5-RAM-16GB-A NVR5 STD 16TB-64TB NVR5 PRM 96TB-160TB...
- Page 2 © 2022, Avigilon Corporation. All rights reserved. AVIGILON, the AVIGILON logo, AVIGILON are trademarks of Avigilon Corporation. Intel is a trademark of Intel Corporation or its subsidiaries in the U.S. and/or other countries. Other names or logos mentioned herein may be the trademarks of their respective owners. The absence of the symbols ™...
-
Page 3: Table Of Contents
Table of Contents Introduction Confirm Package Contents Recommended Tools Installing the NVR5 16 GB RAM Kit Opening the Cover Installing Additional RAM Reattaching the Cover Confirming the Installation For More Information... -
Page 4: Introduction
Introduction Avigilon provides an optional RAM Upgrade Kit for the NVR5 Standard 16-64 TB and Premium 96-160 TB models. Up to eight 8 GB RAM DIMMs are supported per CPU in these NVR5 models. Part Number Description NVR5-RAM-16GB-A NVR5 Standard/Premium 16 GB RAM Upgrade Kit Note: If installing NVR5 RAM Upgrade Kits in a system with two CPUs, kits must be installed in pairs... -
Page 5: Installing The Nvr5 16 Gb Ram Kit
Installing the NVR5 16 GB RAM Kit Note: If the NVR5 is an operating part of your security system, be aware that it must be shut down to complete this procedure. Before starting to install the kit: 1. Turn off the NVR5, including all attached peripherals. Press the power button on the front panel, and wait for the light to stop blinking to indicate shutdown is complete. -
Page 6: Opening The Cover
Opening the Cover 1. At the top of the NVR5, unlock the latch release then lift and rotate the latch towards the back of the unit. The cover slides back and is released from the body. Tip: Use a Phillips #2 screwdriver to remove the shipping screws before unlatching the cover if you are removing the cover of an NVR5 for the first time. -
Page 7: Installing Additional Ram
3. View the interior of the NVR5 and identify the locations where the components of the kit will be installed. The view below shows the details of an NVR5 with all of the covers and cards removed, and important components labeled with numbers. The components affected by the NVR5 Standard/Premium RAM Upgrade Kit are: 3—Memory modules The installed DIMMs are located here. - Page 8 1. Follow the guidelines below based on the appropriate CPU configuration: If upgrading a single-CPU configuration with one RAM Upgrade Kit, install DIMMs into the memory module sockets of CPU 1 following the sequence: A1, A2, A3, A4, A5, A6, A7, A8. For example, on a single-CPU NVR5 Standard with A1 and A2 populated by default, install the pair of DIMMs into sockets A3 and A4.
-
Page 9: Reattaching The Cover
Reattaching the Cover When all the components of the kit have been installed: 1. Reinstall the top of the cooling shroud: a. Align the slot on the air shroud with the standoff in the system. b. Lower the air shroud into the system until it is firmly seated. 2. -
Page 10: Confirming The Installation
Memory should have increased by 16 GB for each RAM Upgrade Kit installed. For example, a single-CPU NVR5 Standard should have upgraded from 16 GB to 32 GB (~32,000 MB) after installing one kit. Limited Warranty Avigilon warranty terms for this product are provided at avigilon.com/warranty. Confirming the Installation... -
Page 11: For More Information
For More Information For additional product documentation and software and firmware upgrades, visit support.avigilon.com. Technical Support Contact Avigilon Technical Support at support.avigilon.com/s/contactsupport. For More Information...
Need help?
Do you have a question about the NVR5-RAM-16GB-A and is the answer not in the manual?
Questions and answers