Table of Contents Introduction Confirm Package Contents Recommended Tools Installing the NVR5 16 GB RAM Kit Opening the Cover Replacing RAM Reattaching the Cover Confirming the Installation For More Information...
Introduction Avigilon provides an optional RAM Upgrade Kit for the NVR5 Premium 192TB-224 TB models. Up to six 8 GB RAM DIMMs are supported per CPU in the NVR5 Premium 192-224 TB models. Part Number Description NVR5-RAM-16GB-A NVR5 Premium 16 GB RAM Upgrade Kit Note: Because the NVR5 Premium 192-224 TB models come with six 8 GB DIMMs pre-installed, this...
Installing the NVR5 16 GB RAM Kit Note: If the NVR5 is an operating part of your security system, be aware that it must be shut down to complete this procedure. Before starting to install the kit: 1. Turn off the NVR5, including all attached peripherals. Press the power button on the front panel, and wait for the light to stop blinking to indicate shutdown is complete.
Opening the Cover 1. At the top of the NVR5, unlock the latch release then lift and rotate the latch towards the back of the unit. The cover slides back and is released from the body. Tip: Use a Phillips #2 screwdriver to remove the shipping screws before unlatching the cover if you are removing the cover of an NVR5 for the first time.
Page 7
Lift the drive tray handles 90 degrees upward. b. Hold the drive tray handles, and lift the drive tray out of the system. 3. View the interior of the NVR5 and identify the locations where the components of the kit will be installed.
Replacing RAM Important: To prevent damage to the DIMM or memory module socket during installation: Do not bend or flex the DIMM. Handle each DIMM only by the edges to ensure that you don't touch the middle of the memory module or the metallic contacts. When installing a DIMM, apply pressure to both ends of the memory module evenly.
Lower the drive tray handles to lock the drive tray in place. 3. Reinstall the top of the cooling shroud. 4. Close and lock the NVR5 cover. 5. If the NVR5 was rack mounted and removed to install the kit, remount it into the rack. Reattaching the Cover...
Confirming the Installation Verify the upgrade is successful: 1. Log in to the ACC Client on a workstation on the same network as the NVR5. 2. In the System Explorer, click Site Setup, and click Site to expand the site containing the upgraded NVR5.
For More Information For additional product documentation and software and firmware upgrades, visit support.avigilon.com. Technical Support Contact Avigilon Technical Support at support.avigilon.com/s/contactsupport. For More Information...
Need help?
Do you have a question about the NVR5 and is the answer not in the manual?
Questions and answers