Table of Contents
Advertisement
STEP 3
1. Pull up the uprights as pictured. Be careful not to squish any cables.
2. Use the 5# Allen wrench to lock the bolt (60) and lock washer (67) on left upright (do not fully tighten).
Then fix the right upright in same way as left upright.
3. You can now fully tighten the Left & Right bolts.
CAUTION:
Do not squish the wires inside the tube and check if wires are connected properly. During
assembly, support the Upright Tubes with your hand to prevent them from falling.
STEP 4
1. Fasten the Left & Right-side cover (27) on the handle bar.
2. Turn the computer display (6) to a suitable angle.
67
60
6
27
ASSEMBLY INSTRUCTIONS |
9
Advertisement
Table of Contents
