LifeSpan Chaser 3 User Manual page 27

TROUBLESHOOTING
Code
E01
E02
E03
E04
E05
E06
E07
E08
E09
E10
Reason
Software runs overload
Hardware is overloaded
IPM module is overheated due to
overload.
1. Input voltage is too low
2. Control board is damaged
1. Input voltage is too high
2. Control board is damaged
Motor open-phase protection
Motor lock-up protection
Motor can't work
Motor over current protection
Overload protection
Solution
Turn off the switch and restart the
machine.
Turn off the switch and restart the
machine.
Turn off the machine for 30 minutes
rest, then restart the machine.
1. Input voltage is too low
2. Control board is damaged
1. Check if the power supply voltage is
normal.
2. If input voltage is normal, please
replace the lower control board.
1. Check whether the motor wiring
is normal, if it is normal, replace the
control board.
2. Change the motor.
1. It is either overload or the motor
rollers is stuck. Check whether
the transmission parts are normal.
Turn off the switch and restart the
machine.
1. The motor/drum is stuck. Check
whether the transmission parts are
normal.
2. Replace the lower control or motor.
1. The machine was running for a long
time. The resistance is high. Put
some oil under running belt
according to instruction.
2. Replace the motor.
1. The machine was running for a long
time. The resistance is high. Put
some oil under running belt
according to instruction.
2. Replace the motor (within the rated
load).
TROUBLESHOOTING | 27