To Initialize The Label Printer; Troubleshooting - Casio KL-750 Owner's Manual

To initialize the Label Printer

1. Turn power off.
2. While holding down the PRINT and ESC keys,
press ON to turn power on.
3. Keeping PRINT and ESC held down, release
the ON key only.
• This prompt confirms whether or not you want to
initialize the Label Printer.
4. Press SET to initialize the Label Printer or ESC to abort the reset operation.
• The following table shows the initial settings.
Item
Display
Memory
SYMBOL
EFFECT
M-FEED
MIRROR
MEMO
DENSITY
WIDTH
INT?
Reset
Cleared
Cleared
,
CANCEL
NO
OFF
STR?
3
OFF

Troubleshooting

Possible Cause
Problem
• Attempt to input two ¥
ERR! message
marks within the same
on the display.
text.
• Attempt to input ¥
mark while 6mm is
specified as the tape
width.
• Label text containing a
¥ mark was input and
then tape width
specification was
changed to 6mm.
(ERR! message appears
when you try to perform
a print operation.)
• Text that is longer than
5.5cm when stamp
printing is selected.
• Attempt to print a stamp
while 6mm is specified
for the tape width.
• Both text memory areas
FUL! message
on the display. (AREA 1 and AREA 2)
already contain text.
• Battery power is too
BATT message
low.
on the display.
• Memory data has
ERR! message
become corrupted for
on the display.
some reason.
Action
• Use only one ¥ mark.
Only two lines of text
can be input, so text
can contain only one
¥ mark.
• Do not use ¥ marks.
6mm tape can have
only one line of text,
so text cannot contain
any ¥ marks.
• Delete the ¥ mark to
print on 6mm tape or
switch back to a wider
tape.
• Shorten the text to be
printed and try again.
• Change the tape width
setting to OFF and try
printing the stamp
again.
• Delete text from one of
the text memory areas
and then store the new
text.
• Replace batteries.
• Initialize the Label
Printer.
E-16