Disc Mode - Casio CW-L300 User Manual

DISC Mode

Symptom Possible Cause
The printing The ink ribbon is used
operation is up.
finished
normally,
but nothing
is printed.
Printing is Any of the following
not clear. can interfere with
Printing is
proper printing.
poor • A disc printing
quality. surface that is not
Printing is
smooth and flat
too light. • A disc printing
surface that has a
design or lines
printed on it
• A disc printing
surface that
supports ink jet
printing only
The ink ribbon
cassette is not loaded
properly.
The color of the final
The printed
color is printout is affected by
different both the color of the
from the ink ink ribbon and the
ribbon color of the disc you
color. are printing on.
60
E
Recommended Action
Load a new ink ribbon
cassette (option). (Startup
Guide, page 11)
Use a disc that meets the
requirements described in the
bundled "Printing Precautions"
or at the following Internet
URL.
http://world.casio.com/ds/
media/
You can also try adjusting the
print density to make it darker.
(page 55)
Re-load the ink ribbon
cassette properly.
Try using a lighter color disc or
a darker color ink ribbon.
Symptom Possible Cause
The printing Improper alignment of
is not
the disc when it is
positioned
placed in the printer.
correctly on
the disc.
The disc The power cord plug
stops part
or the AC adaptor is
way
not plugged in as far
through as it will go.
printing.
The printer is
malfunctioning.
Battery power is low or
the wrong type of
batteries are loaded in
the printer.
Recommended Action
Use the positioning guide
when aligning the disc.
(Startup Guide, page 21)
Correctly connect the power
cord and the AC adaptor.
(Startup Guide, page 7)
If you cannot easily remove
the disc from between the
print head and roller, do not try
to force it. Insert a thin object
into the print head release
button hole (Startup Guide,
page 4) and press to release
the print head. This should
allow you to remove the disc.
After removing the disc, press
the release lever inside the
cassette case (Startup Guide,
page 4) to its original position
before trying to print again. If
you are still unable to remove
the disc from the printer,
contact your retailer or your
nearest CASIO service center.
Use the bundled AC adaptor
to power the printer, or replace
the current batteries with a
fresh set of AA-size alkaline
batteries.