Casio CW-L300 User Manual page 34

■ To specify the size of a string of characters
Example: To change the size of "No Smoking" in the text "No Smoking
here!" to 1× × × × × 3
1.
In the Free Design Mode, input the text you want.
2.
Press SIZE.
3.
Use and to select CHARACTER, and then press SET.
4.
With the highlighting located at the HEIGHT value, use
change the value.
• Here we will change the value to 1.
• You can also input a value with the number keys.
• The printer will beep and not accept your input if you try to input a value
that is not allowed.
5.
Press to move the highlighting to the WIDTH value.
• If you specified the HEIGHT value by pressing a number key, the
highlighting will move the WIDTH value automatically.
6.
Use and to change the WIDTH value, and then press SET.
• Here we will change the value to 3.
7.
Use and to move the cursor to the first character of the string to
which you want to apply the size setting, and then press SET.
• Here, align the cursor with "N".
8.
Use and to move the cursor to the last character of the string to
which you want to apply the size setting, and then press SET.
• Here we will select "No Smoking".
Character Size
Character Size Mark
32
E
and
Auto Fit Mark
Character Size:
Character Size Mark: This mark indicates the point from which a charac-
Auto Fit Mark:
• The character size mark and auto fit mark appear on the display only.
They are not printed in the label.
• To delete a character size mark, move the cursor to the mark and then
to
press DEL.
• Deleting a character size mark causes the text to the right of it to assume
the size of the next character size to the left. Deleting the last character
size mark causes the size of the text to be set by the printer automatically
in accordance with the width of the tape being used and the number of
text lines.
• Note that a character size specification applies up to the end of the current
block. A size specification does not span multiple blocks.
1×3 character size
This indicates the character size at the current cur-
sor position.
ter size specification is applied.
This mark is inserted automatically by the printer to
indicate that the text to the right of it will be adjusted
automatically.
Auto Fit