Sharp JW-20CM User Manual page 79

[Single address and continuous address]
· If a slave station's I/O area is not linked to
the previous slave station's I/O area, this
slave station should be set as a "single
address slave station ."
· If a slave station's I/O area is linked to the
previous slave station's I/O area, you do not
have to set the address this slave station if
"continuous address" is selected (turn OFF
the D bit in the address's upper byte).
7
· If "continuous address" is selected, the address changes in the previous slave station (the top I/
O address in slave station 1 in the example above) will automatically changes the addresses of
the linked slave stations accordingly.
If you want to disable automatic address changes, select the "single address" mode, even if the
slave station address is in a continuous series with the previous slave station addresses. Then
enter the address of the slave station manually.
ｺ0200
Slave
｝
station 1
ｺ0217
ｺ0240
Slave ｝
station 2
ｺ0200
Slave
｝
station 1
ｺ0217
ｺ0220
Slave ｝
station 2
ｺ0237
8 41
·
128 points
Need to set address
128 points
128 points
Select the "continuous
address" setting
(You do not need to set
128 points
addresses for each I/O
area.)
8