Sharp JW-20CM User Manual page 122

Turn "ON" the power of slave module
Connect support tools
· Connect a support tool with the JW-20CM
and prepare the setting parameter.
<Usable support tools>
JW-13PG/12PG
JW-50SP
JW-50PG, Z-100LP2S
• For operation of each support tool, see the
instruction manual attached. The following
describes an example of JW-13PG's key
operation.
Stop PC operation
· Turn to program mode (stop PC operation). Setting of parameters is only available when the PC
is in program mode.
(Operation example of JW-13PG)
Select initial mode
9
Stop operation of data link
· Setting of the parameter is only available when the operation of the JW-20CM is stopped.
· Write "00
(Operation example of JW-13PG)
Display the contents of parameter
address 007777 by hexadecimal.
Reference
•
•
To the next page
Stop PC operation
（
Parameter
setting
[HEX (hexadecimal), byte]
" to parameter address 007777
(H)
（ ）
Write
00
(H)
Function of JW-13PG
key: Changeover unit of figures
→
HEX (hexadecimal)
key: Byte display ←→ Changeover word display
Select parameter setting mode.
）
and stop operation of the JW-20CM.
(8)
Screen display of JW-13PG
07775 HEX
07776 HEX
I PARAM.
.
>07777 HEX
→ →
OCT (octal) DCM (decimal)
9 24
·
00
00
00
→
Bit pattern