Table of Contents
Advertisement
[2] JW-2PU
· Open the terminal block cover, fasten with the screw with torque of less than 12kg·cm.
· Halt output lines can not be connected serial. To use more than two sets, use a relay for
interconnec-tion.
24 VDC
The coil rating must conform to the power supply voltage.
Connect the DC relay in the halt output line and insert the contact with the emergency stop
circuit.
Remarks
留 意 点
· Connect without confusing polarities of input power supply and halt output signal.
· Wrong polarity connection may damage the power supply module when charged.
In case of 24 VDC input
1
Do not use.
2
3
INPUT
4
5
GND
6
7
-
Halt output
+
line
8
DC relay
7
1A
8
Halt output internal circuit
7
9
·
Terminal block
cover
Terminal block
cover
7
Advertisement
Table of Contents
