Chapter 11 Support Tools
The following support tools are available to record (store), and load the contents of the parameter memory.
(Make sure to save the set parameters onto a floppy diskette.)
Ladder software (JW-50SP)
Multipurpose programmer (JW-50PG)
Ladder processor II (Z-100LP2S)
11-1 Record and load by ladder software (JW-50SP)
(1) Record
① Stop operation of the JW-20CM
Select "PC TRANS."
Select "Read."
Select "DL. M. stn. PARAM." or "DL. S. stn.
PARAM."
Set as the function setting condition of the
connected network module.
After selecting "PC stop," press the "Enter"
key.
② Record onto the personal computer
After stopping operation, record the parameters of the JW-20CM onto the memory of the personal
computer.
Select "Read out PARAM" and press the "Enter" key.
Start reading to memory of the personal computer.
③ Start operation of the JW-20CM
After recording the parameters onto the personal computer, start operation of the JW-20CM.
After selecting "Start write EEPROM" or "Execution
start," press the "Enter" key.
Start operation of the JW-20CM
After selecting "PC Run," press the "Enter" key.
Start PC operation
Model name
11
1
·
Applicable floppy diskettes
3.5-inch 2DD/2HD, 5-inch 2DD/2HD
3.5-inch 2DD
3.5-inch 2DD
· Communication adaptor supplied
with JW-50SP
Convertor supplied with JW-50SP
· Control module connection cable
11