Targeted for Commercial applications such as Digital Signage, the PN-TPC1 has been optimized for reliable 1080P video playback. The PN-TPC1 includes a trial version of the Sharp signage software pre-loaded on the hard disk. It also has the flexibility to run most third party software and custom applications.
Getting Started Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Operating systems: Supports Windows Supports Linux Windows XP Pro SP3 installed Software Installed: Sharp Digital Signage Software (SDSS) – 60 day evaluation Microsoft Internet Explorer Microsoft PowerPoint Viewer Windows Media Player QuickTime Player Adobe Flash Player Plug-in ...
Specifications Specifications (con’t) Green Function Supports ACPI (Advanced Configuration and Power Interface) RTC timer to power-on the system AC power failure recovery Onboard Graphics support Integrated 300MHz DAC for analog displays with resolutions up to 1920x1440 at 75Hz. Integrated GeForce VGA / DVI / HDMI ...
Installation Mounting PN-TPC1 on Sharp PN-series Displays 1. Before beginning Make sure to turn off the monitor and remove the AC power. 2. Items needed Sharp PN series Professional Monitor PN-TPC1 Mounting Plate AC Power Adapter 4 x M4 (0.7x10mm) screws 2 x M3 (0.5x5 mm)
Installation 4. Put the AC power adapter Place the AC power adapter into the holder on top of the mounting plate as in Figure 3. AC power cord faces inside and the DC power cord to the PN-TPC1 faces outside. 5.
Installation Rear Connector Layout 1. PS/2 keyboard connector 2. USB Connectors ® 3. HDMI Port 4. S/PDIF Out (Coaxial / Optical) 5. DVI Connector 6. eSATA Connector 7. Audio Port 2-Channel Blue Line-In Green Line-Out Pink Mic In 8. LAN Connector (with LED status indicator) Yellow/Light Up/Blink = 10 Mbps/Link/Activity Yellow and Orange/Light Up/Blink = 100 Mbps/link/Activity Yellow and Orange/Light Up/Blink = 1000 Mbps/link/Activity...
Installation Rear Connector Layout (con’t) 10. Power Connection (refer to the figure in the previous page) Use only the AC power adapter supplied with the system. Input: 100~240V AC 1.5A Output: 19V DC 4.74A Plug the 19V AC/DC adapter (as in the figure 1 above) to the PN-TPC1’s power input jack (as in the figure 2).
If you are trying to recover from a bad HDD, please have a qualified technician runs diagnostics and replaces defective components. If the unit is in warranty, please contact Sharp Customer Service. 2. Items needed Recovery DVD (comes with the unit) USB DVD Drive 3.
TO OBTAIN PRODUCT INFORMATION OR ACCESSORIES, CALL 1-888-GO-SHARP OR VISIT www.SharpUSA.com Trademarks Sharp, SDSS, PN-E and related trademarks are trademarks or registered trademarks of Sharp Corporation and/or its affiliated entities. NVIDIA, ION, GeForce and nView are trademarks or registered trademarks of NVIDIA Corporation.