Powerfix Profi 283350 Operation And Safety Notes page 6

Adjusting the drill size
(see Fig. A)
1. Turn the latch counter-clockwise to unlock.
5
2. Push and hold the latch
3. Turn the setting dial
the respective drill size.
4. Release and turn the latch
the product again.
Attaching the depth stop
(see Fig. B and C)
Slide the desired depth stop
respective wood drill
wrench to tighten the hexagon head screw
4
and secure the depth stop
position.
Attaching the rip fence to the
product (see Fig. D and E)
1. Turn the latch counter-clockwise to unlock
5
the product. Press and hold the latch
2. Insert the rip fence
3. Release the latch
5
4. Turn the latch clockwise to lock the rip
5
fence .
7
Drilling holes (T-joints)
Note: This requires a cordless drill.
CAUTION! RISK OF INJURY! Please refer to
your cordless drill's instructions for use.
Secure board A to the workbench.
First mark the centre line on board A (see Fig. F),
then the location where you wish to drill the
hole with an „x".
Apply the product to the board A and adjust
the rip fence so the selected jig is exactly in
7
the location marked „x". You can check and if
necessary correct the positions of the mark
6 GB
.
5
until the arrow points at
6
clockwise to lock
5
over the
2
. Use the installation
1
in the desired
2
.
5
in the product.
7
.
using the measuring scale
the product (see Fig. G).
Drill the hole in the marked location (see Fig. H).
Make a line in the location on board B where
you wish to later attach board A (see Fig. I).
Remove the rip fence
pressing and holding the latch
the rip fence out toward the back.
7
Now clamp board A in the workbench parallel
to board B as shown in figure J.
Align the product so the guide
previously drilled hole in board A and the
selected jig is exactly over the line on board B
(see Fig. J).
Now drill the hole in board B.
Then insert a dowel
(not included) in the hole (see Fig. K).
Repeat this process as often as necessary.
Drilling holes (L-joints)
Note: This requires a cordless drill.
CAUTION! RISK OF INJURY! Please refer to
your cordless drill's instructions for use.
Secure board A to the workbench.
First mark the centre line on board A (see Fig. F),
then the location where you wish to drill the hole
with an „x".
Apply the product to the board and adjust the
rip fence so the selected jig is exactly in the
7
location marked „x". You can check and if nec-
essary correct the positions of the mark using
the measuring scale
product (see Fig. G).
Drill the hole in the marked location (see Fig. H).
Mark the location where you wish to later
attach board A with a line (see Fig. L).
Pull the guide out of the product and slide
9
into the rip fence
7
Now clamp board A in the workbench parallel
to board B as shown in figure M.
Align the product so the guide
previously drilled hole in board A and the
selected jig is exactly over the line on board B
(see Fig. M).
on both sides of
8
from the product by
7
and pulling
5
is inside the
9
coated with wood glue
3
on both sides of the
8
from below (see Fig. M).
is inside the
9