Subscribe to Our Youtube Channel
Related Manuals for Wren Kitchens Vogue TOWER UNIT 300 Pull Out 2070
Summary of Contents for Wren Kitchens Vogue TOWER UNIT 300 Pull Out 2070
- Page 1 TOWER UNIT 300 - 600 Pull out Swing Assembly Guide 300 Pull Out 600 Easy Pull 2070 Out Swing 2070 300 Pull Out 600 Easy Pull 2250 Tall Out Swing 2250 Tall For Internal Use: FI.WR.INS.044.TOWER_300_600_2DrPullSwing.Rev11...
- Page 2 TOWER UNIT 300 - 600 Pull out Swing Assembly Guide BEFORE YOU START INSTALLATION SHOULD BE PERFORMED BY A COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Panel A Panel C Panel B Panel E Legs Frontals x1 Back Panel x2 Base Panel x2 End Panel...
- Page 3 Step 1. Seat (G) Step 2. Seat dowel (F) into holes in Cam Dowel Seat cam dowel (G) into both end panels (B) as shown. into hole as holes in both end panels shown. (B) as shown. G F F Step 3.
- Page 4 TOWER UNIT 300 - 600 Pull out Swing Assembly Guide Step 5. Slide back panel (A) into groove of end panels (B). Once back panel (A) is in position, ensure the panel is flush & square with bottom of end panels (B). Step 6.
- Page 5 Step 8. Position legs as shown. Ensure legs are rotated to also provide support to the end panels (B). Front Standard Leg Additional Leg Additional Leg Base Front Leg position diagram Step 9. Secure each of the legs into place with 4 x 15mm screws (L) per leg.
- Page 6 TOWER UNIT 300 - 600 Pull out Swing Assembly Guide See Customer Specific Kitchen Plan 2006mm For Tower Frontals 1974mm 1826mm 1794mm Step 11. (Not required for 300). 1426mm Attach hinge plates onto end panels 1394mm 1336mm (B) to suit as shown using 2 x screws 1304mm already located in the hinge plate.
- Page 7 300 Pull Out Please refer to separate instructions included with your pull out. Then no further assembly steps are needed. Reverse of Frontals Insert cover caps as shown. Winged Winged Cover Caps Plug Plug Plug Cover Caps Winged Repeat on other side for Handleless Frontals For Internal Use: FI.WR.INS.044.TOWER_300_600_2DrPullSwing.Rev11 Page 6...
- Page 8 TOWER UNIT 300 - 600 Pull out Swing Assembly Guide Step 12. Insert hinge where required in holes as shown. Step 13. Secure hinges by tightening 2 x screws with hinge dowels attached. These are already positioned within the hinges. Step 14.
- Page 9 600 Pull & Swing Please refer to separate instructions included with your pull out. Step 3 of pull out instructions For Steps 3 of Pull Out instructions. Use (L) screws Step 4 of pull out instructions For Steps 4 of Pull Out instructions.
- Page 10 TOWER UNIT 300 - 600 Pull out Swing Assembly Guide Page 9...
- Page 11 For Internal Use: FI.WR.INS.044.TOWER_300_600_2DrPullSwing.Rev11 Page 10...
Need help?
Do you have a question about the Vogue TOWER UNIT 300 Pull Out 2070 and is the answer not in the manual?
Questions and answers