Controller Firmware - Kohler 6VSG Service Manual

3.4 Controller Firmware

The manufacturer may release new versions of
controller firmware. Kohler
the latest software from the TechTools area of the
Kohler Power Resource Center website. Controller
firmware is also available for download on the Kohler
dealer portal and at www.kohlerpower.com/oncue.
The firmware version number is shown in the VSC
controller's Overview menu.
Figure 3-10. The firmware version number is also
displayed in SiteTech and OnCue.
A personal computer (laptop), a USB cable, and
Kohler ® SiteTech ™ or OnCue
for firmware updates. Use a USB cable to connect the
computer to the controller's USB port. See Section
3.2. To check the firmware version number, select the
parameters view in SiteTech or OnCue. The firmware
version number is shown in the Identity Group, which
is the first group displayed.
Refer to the SiteTech Software Operation Manual or
the OnCue Software Operation Manual for instructions
to load new firmware onto the controller.
Firmware version numbers: Preceding zeros may be
dropped from firmware version numbers.
example, version number 4.03 is the same as version
4.3. The version number displayed in SiteTech may
show a third number.
display version 4.3.5 for software version 4.3.
TP-6844 1/13
®
distributors can download
See SW Version in
® software are required
For example, SiteTech may
Figure 3-10
Overview ---->
1.2 h
For
Figure 3-10 Firmware (SW) Version Number in
Overview Menu
Active Alert
(if any)
Genset Status
Standby
Generator: 54V
% Load 73%
Engine: 125F
Oil Pressure: OK
Battery:
13.3 V
Engine Runtime:
100.6 h
Date: 17Jul2012
Time: 07:09pm
Next Exercise:
09:00p 18Jul2012
Next Maintenance:
100 h or Jan2013
SW Version:
1.0
<---- Return
Section 3 Controller 37