Section 3 Controller; Introduction; Sitetech And Oncue Software - Kohler 6VSG Service Manual

3.1 Introduction

The VSC controller manages the operation of the
generator set and
Interface Module (PIM).
Operation Manual for controller operation instructions.
This section covers adjustment and replacement of the
VSC controller. See Section 4.10 for troubleshooting
information.
The VSC controller is shown in Figure 3-1. See the
service view, Figure 1-6, for the controller location.
Figure 3-1
Figure 3-1 VSC Controller

3.2 SiteTech and OnCue Software

Many procedures in this manual require the use of a
personal computer (or laptop) with Kohler
software to change controller settings or update
firmware. SiteTech
Kohler-authorized distributors and dealers. See the
SiteTech Operation Manual, TP-6701, for general
software operation instructions.
Some procedures can be also performed using
® ®
Kohler OnCue software
connected to the computer with a USB cable. See
Figure 3-3.
Use a USB cable to connect the personal computer
directly to the device. See Figure 3-3. The USB cable
must have a male USB A connector on one end and a
male mini-B connector on the other and must be less
than 5 m (16.4 ft.) long. See Figure 3-2.
TP-6844 1/13
the optional Programmable
See the generator set
KPS_048
GM77569
® SiteTech™
software is available
if the controller
Figure 3-2
1. Detail, mini-B connector
Figure 3-2 USB Cable
to
is

Section 3 Controller

1
Section 3 Controller
KPS_066
27