Controller Firmware - Kohler Power Systems 8RESV Service Manual

3.4 Controller Firmware

The manufacturer may release new versions of
controller firmware. Kohlerr distributors can download
the latest software from the Kohler Power Resource
Center website. Controller firmware is also available for
download on the Kohler dealer portal or at
www.kohlergenerators.com/usb.
A personal computer (laptop), a USB cable, and
Kohlerr SiteTecht or USB Utility are required for
firmware updates (updating controller firmware is not
available with OnCue Plus).
connect the computer to the controller's USB port. See
Section 3.2 for USB connection information.
The firmware version number is shown in the
controller's Overview menu.
Figure 3-5. The firmware version number is also
displayed in SiteTecht and OnCuer Plus software
under parameters. In SiteTech, the firmware version
number is shown in the Identity Group, which is the first
group displayed. Refer to the SiteTecht, OnCuer Plus,
or USB Utility software manuals for specific instructions.
Firmware version numbers: Preceding zeroes may be
dropped from firmware version numbers. For example,
version number 4.03 is the same as version 4.3. The
version number displayed in SiteTech or OnCuer Plus
may show a third number. For example, SiteTech may
display version 4.3.5 for software version 4.3.
For instructions about loading new firmware onto the
controller, refer to the SiteTech Software Operation
Manual or the USB Utility Instructions.
44 Section 3 Controller
Use a USB cable to
See SW Version in
Overview ---->
1.2 h
Figure 3-5 SW Version Number in Overview Menu
Active Alert
(if any)
Genset Status
Standby
Voltage: 240V
Freq: 60.0Hz
Engine: 85F
Oil Pressure: OK
Battery
12.3V
Engine Runtime:
25.5 h
Date: 02DEC2011
Time: HR:MNpm
Next Exercise:
09:00p 09Dec2011
Next Maintenance:
150 h or Mar2012
SW Version:
4.03
<---- Return
tp6804
TP-6881 7/15