Page 2
Bu ton ove view Po t ove view Telephone LAN po ts Power po t po t Unlock bu ton Remove FiberTwist or Blind Cover – press and hold while wisting counterclockwise Reset bu ton (recessed) Reset – press and release LED dim bu ton Dim LEDs –...
Page 3
LED ove view System Green – system ok Green (blinking) – booting – system error Red (blinking) – insu icient optical signal – power o Uplink Green – link ok Green (blinking) – link ok, no remote management – no link Phone Green –...
Page 4
Various translations of this document (if available) and additional product Remove Blind Cover (if present) information can be found on h tps: genexis.eu product ibe wist downloads . Press and hold the unlock bu ton (see bu ton ove view). . Rotate the Blind Cover counterclockwise till it blocks.
Page 5
Remove dust cap Twist! . Take the FiberTwist out of the box. . Place the FiberTwist on the FTU as shown in the picture below. . The dust cap is connected to the red string located on the rear of the FiberTwist. .
Page 6
. If required, connect your telephone to the phone po t via an RJ ne work cable. . If required, connect your personal devices to the LAN po ts via an RJ Hereby, Genexis Netherlands B. V . declares that the product FiberTwist P B is ne work cable.
Need help?
Do you have a question about the FiberTwist Series and is the answer not in the manual?
Questions and answers