Genexis FiberTwist Series Installation Manual
Hide thumbs
Also See for FiberTwist Series:
- Installation manual ,
- Installation manual (7 pages) ,
- Installation manual (7 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Genexis FiberTwist Series
Summary of Contents for Genexis FiberTwist Series
- Page 1 F2115-2 FiberTwist–Series Installation Guide...
- Page 2 Button overview Port overview Unlock button LC/APC coupler Remove FiberTwist or Blind Cover – press and hold while twisting counterclockwise...
- Page 3 2. Rotate the Blind Cover counterclockwise till it blocks. Box contents Important: Instructions need 3. Remove the Blind Cover from the baseplate (FTU) by pulling • Genexis FiberTwist-F2115-2 to be followed precisely and it towards yourself. uninterrupted. This minimizes 4. Store the Blind Cover in a safe place.
- Page 4 Remove dust cap Twist! 1. Take the FiberTwist out of the box. 1. Place the FiberTwist on the FTU as shown in the picture below, 2. The dust cap is connected to the red string in a 30–degree angle. located on the rear of the FiberTwist. 2.
- Page 5 Revision 1.0 - May 2021- Copyright © 2021 Genexis Netherlands B. V . All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.
Need help?
Do you have a question about the FiberTwist Series and is the answer not in the manual?
Questions and answers