Button overview Port overview Telephone LAN ports Power port port Unlock button Remove FiberTwist or Blind Cover – press and hold while twisting counterclockwise Reset button (recessed) Reset – press and release Factory reset – press and hold 5 seconds LED dim button Dim LEDs –...
LED overview System • Green – system ok • Green (blinking) – booting • Red – system error • Red (blinking) – insuff icient optical signal • Off – power off Uplink • Green – link ok • Green (blinking) –...
Page 4
• Rotate the Blind Cover counterclockwise till it blocks. Box contents Important: These instructions • Remove the Blind Cover from the baseplate (FTU) by pulling • Genexis FiberTwist (active device) need to be followed precisely and it towards yourself. • Power adapter uninterrupted.
Page 5
Remove dust cap Twist! • Take the FiberTwist out of the box. • Place the FiberTwist on the FTU as shown in the picture below, • The dust cap is connected to the red string in a 30–degree angle. located on the rear of the FiberTwist. •...
• Connect phone and LAN cable(s) as required. • Connect the supplied power adapter to the FiberTwist and plug the adapter into Hereby, Genexis B. V . declares that the product FiberTwist-P2414 is in compliance a power socket. with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU and Delegated Directive 2015/863.
Need help?
Do you have a question about the FiberTwist Series and is the answer not in the manual?
Questions and answers