Download Print this page
Genexis FiberTwist Series Installation Manual

Genexis FiberTwist Series Installation Manual

Wi-fi easymesh supported
Hide thumbs Also See for FiberTwist Series:

Advertisement

Quick Links

P
FiberTwist Series
Installation Guide
Wi-Fi EasyMesh™ suppo ted

Advertisement

loading
Need help?

Need help?

Do you have a question about the FiberTwist Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Genexis FiberTwist Series

  • Page 1 FiberTwist Series Installation Guide Wi-Fi EasyMesh™ suppo ted...
  • Page 2 . Press and hold the unlock bu ton (on the right side of the Blind Cover or active device). found on h tps: genexis.eu product ibe wist downloads . Rotate the Blind Cover or active device counterclockwise till it blocks.
  • Page 3 Remove dust cap Twist! . Take the FiberTwist P out of the box. . Place the FiberTwist P on the FTU Bracket as shown in the picture below. . The dust cap is connected to the red string . Rotate clockwise until it clicks into place. located on the rear of the FiberTwist P .
  • Page 4 Se ting up the FiberTwist P Connecting to the wireless ne work Using the web inte face Power saving options . If required, connect your telephone to a You can connect your personal device to You can access the FiberTwist P Power saving options are available via the green telephone po t via an RJ the FiberTwist P...
  • Page 5 LED ove view Uplink Green – optical WAN link is established Green (blinking) – optical WAN link is in progress Red (blinking) – insu icient optical input signal – no optical WAN link detected Internet (IP connectivi y) Green – connected (DNS available) Green (blinking) –...
  • Page 6 Bu ton ove view Unlock bu ton Remove FiberTwist P – press and hold while wisting counterclockwise Mode bu ton Pairing (WPS) – press and release once WiFi ON – press and hold until WiFi LED turns solid green WiFi OFF –...
  • Page 7 Po t ove view ON OFF switch Telephone Reset Power po t LAN po ts po ts bu ton Unlock bu ton LED dim bu ton Dim LEDs – press and release repeatedly USB . to dim LEDs po t Reset bu ton (recessed) ON OFF switch Reboot...
  • Page 8: Troubleshooting

    EU Declaration of Conformi y Is the Status LED solid red? Is the Internet LED blinking green for Hereby, Genexis Netherlands B. V . declares that the radio equipment ype FiberTwist P is in Contact your se vice provider. minutes?
  • Page 9 - Copyright © Genexis Netherlands B. V . All rights rese ved. Genexis assumes no responsibili y for any inaccuracies in this document. Genexis rese ves the right to change, modify, transfer, or othe wise revise this publication without notice.

This manual is also suitable for:

Fibertwist 6000 seriesP6416