How To Check Prism Ratio - Cornelius PRISM Owner's Manual

Prism Owner's Manual
H T C P
OW O HECK
!
CAUTION:
Do not expose the capacitive touch module wire to water.
Step Action
1. Remove the capacitive touch
module by lifting it upward and
pulling out. Remove the rear
valve cover. Leave the wire
attached to the capacitive touch
module.
Place the ratio cup under the
2.
valve.
Place the dip switch into "Brix
3.
mode".
Press the water button to
activate a time dispense of 4.0
sec. Target 10oz into the water
chamber of the ratio cup.
NOTE: After the water flow is
4.
adjusted, note the level
of the ratio cup. Do not
adjust the water again
for the syrup.
Publication Number: 548000037
R
RISM ATIO
Wires from valve body
to Capacitive touch modules
Capacitive Touch Module
Table 2.
Figure
Figure 5.
Figure 6.
Brix Cup
Figure 7.
- 6 - © 2022, Marmon Foodservice Technologies Inc.
Rear Cover
Valve Body
Brix Mode