Table of Contents
Advertisement
The power cord or plug is damaged.
Liquid has penetrated into equipment.
The equipment has been exposed to moisture.
The equipment does not work well, or you cannot get it to work according to the user's
manual.
The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.
5. Do not use liquid or spray detergents for cleaning and keep this equipment away from
humidity.
Caution! To avoid short-circuiting and otherwise damaging the device, do not allow fluids to come
in contact with the device. If fluids are accidentally spilled on the equipment, remove the
affected unit from service as soon as possible and contact the service personnel to
verify that patient safety is not compromised.
Précaution! Pour éviter tout court-circuit et autrement endommager l'appareil, ne laissez pas de
liquides entrer en contact avec l'appareil. Si du liquide est accidentellement renversé
sur l'équipement, retirez l'unité affectée du service dès que possible et contactez le
personnel d'entretien pour vérifier que la sécurité du patient n'est pas compromise.
6. Put this equipment on a reliable surface during installation. Dropping it or letting it fall
may cause damage.
7. To prevent overheating, do not place the device in direct sunlight or near radiant heaters.
8. VESA bracket kit installation should be operated by professional technician, please
contact the service technician or your retail if you need this service.
9. Environmental protection: follow national requirements to dispose of unit.
10. Make sure the user not to contact SIP/SOPs and the patient at the same time.
11. Maintenance: to properly maintain and clean the surfaces, use only the approved
products or clean with a dry applicator.
12. Accessory equipment connected to EPB-1001 must be in compliance with the
respective nationally harmonized IEC standards (i.e. IEC 60950 for data processing
equipment, IEC 60065 for video equipment, IEC 61010-1 for laboratory equipment, and IEC
60601-1 for medical equipment.) Furthermore, all configurations shall comply with the
system standard IEC 60601-1-1. Everybody who connects additional equipment to the
signal input part or signal output part configures a medical system, and is therefore,
responsible that the system complies with the requirements of the system standard IEC
60601-1-1. The unit is for exclusive interconnection with IEC 60601-1 certified equipment in
the patient environment and IEC 60601-1 certified equipment outside of the patient
environment. If in doubt, consult the technical services department or your local
Quick Reference Guide
EPB-1001 Quick Reference Guide
3
Advertisement
Table of Contents
