Table of Contents
Advertisement
3.
INSTALLATION
1.
Unpack the TrakaMEC Cabinet and the Plinth (if applicable) from the box.
2.
Ensure you keep hold of your Handle Code card. There is a second located inside the Cabinet.
3.
Locate the desired position on the wall/floor you wish the TrakaMEC Cabinet to be installed.
4.
Position the Plinth in desired location. Ensure the top of the Plinth is level with the wall and the bottom of the
Plinth faces as shown in the image below.
V1.0 04/02/20
This Document is uncontrolled when printed unless over stamped "CONTROLLED DOCUMENT"
TD0192
Page 8 of 13
Advertisement
Table of Contents
