Advertisement
THE CHASSIS
1. Use rubbing alcohol and a rag to clean and de-grease the top chassis and bottom chassis, both
outside and inside.
57
2. Attach the labels:
a. Remove all the punch-outs from the main label (including the rectangle hole for the display).
Place the top label onto the top of the chassis and line up all the holes. Try to make sure all
the holes in the chassis are in the very center of the label holes(59). Use some tape to hold
one side of the label to the top chassis in the proper place. Lift the side of the label that isn't
being held down by tape and peel away and cut off about half of the backing (60).
Carefully lay and smooth the label back down on the chassis top. Rub it down thoroughly.
Remove the tape and remove the remaining backing. Smooth down the other side of the
label.
59
61
58
60
20
Advertisement
