Advertisement
b. Carefully place the top chassis onto the bottom chassis. While aligning the switches, pots,
and display, slide the two pieces together. You may need to reach in with your finger and
adjust the ribbon cables so that they will lay correctly and allow the pieces to slide all the
way together.
102
c. Use the four ¼" screws to hold the chassis together.
104
6. Testing your Altura: Turn all the knobs to the furthest counter clockwise position. Plug a 9 volt
battery or a 9 volt (center negative) power supply into your freshly built Altura. Turn your Altura
on by pressing the power button. If everything was put together correctly you should see a 3
digit number on the display, which indicates the software version number.
That's it!
You're now ready to use your Altura. Please see the Altura MkII Quick Start Guide and Reference
Manual to get the most out of your new Theremin MIDI Controller.
103
105
27
Advertisement
