Advertisement
3. Push the little red cap (part #SW-60-22) onto the power switch (96). If the button seems a little
loose, add a tiny drop of super glue to the switch shaft before installing the button.
96
4. Open up the battery holder and pull the battery snap cable all the way into the compartment.
This way, the battery snap cable won't get hung up on anything on the circuit board once the
chassis is fully assembled.
98
5. Assembling the chassis:
a. Bring the two chassis parts together and plug in the ribbon cables to the "Left Sensor" and
"Right Sensor" headers on the PCB. Make sure that the ribbon cable is NOT TWISTED. The
two ridges on the female header should be facing toward the inside of the board.
100
97
99
101
26
Advertisement
