Advertisement
PUTTING IT ALL TOGETHER
1. Before you install the PCB into the bottom chassis, you need to place the battery snap into the
battery box. Slide the snap through the larger opening in the base of the battery box. You may
need to push and finagle it around the battery box screw to get it to fit.
90
2. Once the battery snap is in the battery box, slide the PCB into place on the bottom chassis. You'll
have to depress the power switch to get it to slide all the way into place (93). Align the 4 holes
in the corners of the circuit board onto the 4 threaded standoffs in the chassis base. Use the
1/2" screws to attach the board to the chassis (94).
92
94
91
93
25
Advertisement
