Advertisement
d. Install the sensors to the inside of the top part of the chassis. Make sure the header on the
sensors is pointing away from the top of the chassis. Use a #2 Philips screw driver and two
coarse-thread M3x10 screws (part #FA-64-30) to install each sensor into the chassis. Do not
over tighten these screws. Tighten them just enough so that the head of the screw is flush with
the chassis.
84
86
e. Optionally, to keep the sensors from sliding back and forth in their brackets, you can use a
drop of hot glue (or even super glue) to tack the sensors to the brackets.
88
85
87
24
Advertisement
