Advertisement
6. Potentiometers:
a. Install the potentiometers (aka "pots"). Make sure they are all seated securely and flush
against the PCB; otherwise the completed board won't fit properly into your Altura's case
(31). Double check that the shafts of the pots are all standing at 90 degrees to the board
(32)
31
b. Solder the pots. When soldering do not use too much heat. If you cannot move quickly with
your iron, solder one pin on each pot sequentially. This will allow each pot to cool before
you solder its next pin (33). Make sure all five pins of each pot are soldered.
33
32
34
16
Advertisement
