Advertisement
5. Tact Switches:
a. Use a tiny drop of super glue to attach the little button caps (part number SW-60-23) to each
of the switch actuators (24,25). You don't need much glue, less than a drop each! Make sure
each cap is pressed down tight to the tip of the actuator; otherwise it won't fit properly in the
case. Let the glue fully set up before you move on with the next step.
24
26
b. Install/solder tact switches Install the tact switches at S2, S3, S4 (28,29). It doesn't matter
which direction they are installed. The pins should snap into place. Solder all the pins on the
solder side (30)
28
30
25
29
15
Advertisement
