R&S NGE102B Getting Started page 21

®
R&S NGE100B
AC inlet with fuse holder (8)
Main supply cord
Do not use detachable mains supply cord with inadequate rating.
For safety reasons, the instrument can only be operated with authorized safety
sockets.
The power cable must be plugged in before signal circuits can be connected.
Never use the product if the power cable is damaged. See
ing on the instrument",
Voltage selector (9)
Setting voltage selector
The voltage selector is located at the bottom of the R&S NGE100B.
On your first power-on connection, a yellow label sticker is attached over
the AC inlet. Before peeling off the yellow label sticker, make sure the cor-
rect fuse rating is used for the mains voltage.
To set the correct fuse rating, slide the selector according to the voltage
selector label.
Figure 6-3: Voltage selector
1 = Voltage selector
2 = Voltage selector label
Getting Started 5601.1337.02 ─ 08
on page 22 for more information.
1
2
Instrument tour
Overview of controls
Chapter 6.2, "Switch-
21