R&S NGE102B Getting Started page 14

®
R&S NGE100B
Provide adequate airflow
Do not block the air intake at the front and side of the instrument or the exhaust at
the rear. Install the instrument on a location that allows sufficient space for air cir-
culation at the air intake and exhaust. Recommended spacing to non-heat pro-
ducing surface is at least 2.5 inches (63.5 mm) from the ventilation holes.
Applicable local or national safety regulations and rules for the prevention of acci-
dents must be observed in all work performed.
The instrument is designed for use in the following sectors: Industrial, residential,
business and commercial areas and small businesses.
The instrument is designed for indoor use only. Before each measurement, you
need to verify at a known source if the instrument functions properly.
To disconnect from the mains, the low-heat device socket on the back panel
has to be unplugged.
See Table 5-1 for the general data on the instrument specification. For more infor-
mation, see the instrument product brochure (PN: 5214.8748.12).
Table 5-1: General data on instrument specification
Mains nominal voltage
Power consumption
Mains fuses
(fuse size: 5 mm x 20 mm)
Temperature
Humidity
Display
Rack mount capability
Dimensions
Weight
Getting Started 5601.1337.02 ─ 08
AC
Maximum input power
115 V AC
230 V AC
Operating temperature range
Storage temperature range
Non-condensing
½ 19 "
W x H x D
R&S NGE102B
R&S NGE103B
Putting into operation
Intended operation
115 V / 230 V (±10 %) 50 Hz /
60 Hz
180 W
IEC 60127-2/5 T 5 A 250 V
IEC 60127-2/5 T 2.5 A 250 V
0 °C to + 40 °C
- 20 °C to + 70 °C
5 % to 80 %
3.5 " (QVGA)
R&S HZC95 option
222 mm x 88 mm x 280 mm
(8.74 in x 3.46 in x 11.02 in)
4.9 kg (10.80 lb)
5.0 kg (11.02 lb)
14