Pre-Warm Or Pre-Cool The Centrifuge; Programs; Figure Iii-13: Select Program - Thermo Scientific Sorvall BP 8 Instruction Manual

Thermo Scientific Sorvall BP 8 / 16 and Sorvall BIOS 16 Centrifuges and Heavy Duty Centrifuges
6. 5.

Pre-warm or Pre-cool the Centrifuge

To pre-temp the centrifuge, proceed as follows:
1. Use Configuration and Runs to select a stored program. The pre-temp function is connected to a program.
2. Press Load to select programmed parameters. In the main screen you can then set the required target temperature.

7. Programs

For detailed instructions and information refer to the according manual for the Thermo Scientific Centri-Touch User Interface.
The instructions stated here are just an extract of how to work with programs.
1. Press on the touchscreen.
If a program is already loaded, the program name will be shown on the button.
Figure III–13: Select program
2. Press New.
a. Check the parameter. Change the parameter if necessary.
To change a parameter, press the button of the parameter you want to change.
Press Apply.
Press Enter Name.
b.
Enter a name for the program.
Press Apply.
c. Press Select Rotor.
Select a rotor.
Press Apply.
Select a bucket using the drop-down menu.
Press Apply.
Press Apply to save the program.
3.
4. Press the new created program.
Press Load.
The program is now loaded and can be used.
Operation
III–11