Monogram 15900-012 Assembly page 51

COMPONENT MAINTENANCE MANUAL
C. Drain Valve Assembly, PN 4650-23 (refer to IPL Figure 3) as follows:
(1) List of Materials
NOTE:
ITEM
Lubricant
(2) Procedures
(a) Install plate support (110) seal plug (115), seal (105) and plate (100) on valve
stem assembly (120), secure with nut (95).
(b) Install O-rings (90).
(c) apply silicone grease (Dow Corning 33) to grooves in base of housing (85).
(d) Install housing (85) over the valve stem assembly (120) until valve assembly
projects above the mounting plate of the housing. Install spriolox (80) in groove
of valve stem assembly (120).
(e) Slide spring (75) into valve stem assembly (120).
(f) Supporting the housing (85) by the mounting plate, compress spring (75) by
pushing cover (60) into position on four mounting studs of the housing.
(g) Install washers (70) and nuts (65) to secure cover (60) to the housing (85).
(h) Insert loose end of cable (45) through the top of pulley slot to bottom of valve
stem assembly (120). Tighten cable (45) using nut (50) and washer (55).
(i) Install pulley (5), using clevis pin (20), washer (15 and 35), and drilled pin (30)
and cotter pins (10 and 40).
Monogram Sanitation
PN 15900-012 Series
Equivalent substitutes may be used for listed items.
DESCRIPTION
No. 33
SOURCE
Dow Corning
38-31-07
Page 709
Jan 10/95