Monogram 15900-012 Assembly page 40

3. Repair Procedures
A. Top and Tank Assembly
Due to structural considerations, cracks, fractures, delamination and ruptures of the top and
tank assembly necessitates replacement of factory repair.
B. Motor-Pump-Filter Assembly
(1) Motor Assembly
Brush holder cap and Brush assembly are the only replaceable parts within the motor
assembly.
(2) Refinish
Refinish exterior painted surfaces of the motor assembly as follows:
(a) Sand all chipped, loose paint and corroded areas of the motor assembly.
(b) Paint all exposed areas of motor assembly with one coat of epoxy primer and a
(3) Replace all damaged or otherwise illegible nameplate identification or decals.
C. Drain Valve Assembly
(1) Deburring and chasing of stud threads and threaded fittings is acceptable as long as no
more than two consecutive threads are damaged.
(2) Dimpled mounting plate holes may be flattened as long as hole diameter deformation
does not occur.
(3) Part number identification removed or otherwise destroyed shall be reapplied.
Monogram Sanitation
COMPONENT MAINTENANCE MANUAL
PN 15900-012 Series
coat of epoxy enamel.
38-31-07
Page 602
Jan 10/95