Monogram 15900-012 Assembly page 48

COMPONENT MAINTENANCE MANUAL
(e) Install spray nozzle (135) with washers (130) on each side, securing it with cotter pin
(125).
(f) Position drive shaft assembly (120) with thrust washer (110) on impeller housing
(115).
(g) Install thrust washer (110), impeller (105), thrust washer (100), and retaining ring (95)
on drive shaft assembly (120).
NOTE: Use thrust washers (110) as required to ensure full engagement of motor
drive shaft. Maintain a minimum clearance of 0.005 inch (0,13 mm) between
impeller and impeller housing (115).
(h) Install impeller housing plate (75) with impeller housing (115), using screws (80),
washers (85), and nuts (90) to frame assembly (195).
(i) Install filter basket (60), using washer (70) and nut (65).
(j) Install seals (55) and adapter plate (50), applying lubricant (Lubriplate 105) as shown
in Figure 701.
Cross Section of Mounting Plate
Monogram Sanitation
PN 15900-012 Series
Figure 701
38-31-07
Page 706
Jan 10/95