Monogram 15900-012 Assembly page 30

E. Liquid Level Transmitter Assembly, PN 13503-106 (refer to IPL Figure 5)
(1) Remove case (5) by removing lockwire, screws (10) and washers (15).
(2) Remove supports (20).
(3) Remove lug (25) ground wire assembly from case (5) by removing screw (30), nylon washer
(35) and nut (40).
(4) Remove connector (45) by removing screws (50), flat washers (55), lock washers (60), nuts
(65) and gasket (67).
(5) Disconnect connector plug (120) from receptacle (70).
(6) Remove ground wire assembly from harness of light driver PC board (130), by cutting twine
ties.
(7) Remove and discard seal (75).
(8) Remove mounting plate (80) by removing screws (85) and nylon washers (90).
(9) Remove washers (95).
(10) Remove grommets (100).
(11) Remove lug (105).
(12) Remove spacers (110 and 115).
(13) Separate bridge PC board (125) from light driver PC board (130).
(14) If needed, remove and replace schematic decal (135) and nameplate (140).
Monogram Sanitation
COMPONENT MAINTENANCE MANUAL
PN 15900-012 Series
38-31-07
Page 306
Jan 10/95