Monogram 15900-012 Assembly page 47

COMPONENT MAINTENANCE MANUAL
B. Motor-Pump-Filter Assembly, PN3511-007 (refer to IPL Figure 2)
(1) List of Materials
NOTE: Equivalent substitutes may be used for listed items.
ITEM
Lubricant
Adhesive
Lockwire
(2) Procedure
(a) Apply a uniform film of sealant, EC 1239 (3M Co.) to periphery of the frame
assembly (195). Install mounting plate (215) on frame assembly, using screws
(200), washer (205), and nuts (210).
(b) Install flapper (165) by pulling installation tail through hole in antisiphon housing
(140). Trim tail .010-.030 inch (0,25 to 0,76 mm) from bulb if new flapper is
being used.
(c) Position retention washer in place on inlet tube (190) and install both with
gasket (180) on antisiphon housing (140), using washers (175), and nuts (170).
(d) Install antisiphon housing (140), with gasket (160) on mounting plate (215),
using screws (145), washers (150), and nuts (155).
Monogram Sanitation
PN 15900-012 Series
DESCRIPTION
Lubriplate 105
3MNo. 1239
MS20995C32
Assembly Materials
Table 701
SOURCE
Fiske Bros., Refining Co.
Newark, NJ 73219
Minnesota Mining &
Manufacturing Co.
Adhesive Division
St. Paul, MN 55101
Any government approved
source
38-31-07
Page 705
Jan 10/95