Xtracycle RFA Assembly Manual page 5

12
Find the battery charger and domestic power cable in the
small parts box. Locate the charging port on the drive side
of the battery. Pull back the rubber cover and plug in the
charging cable.
14 - Install the RFA KickBack
Bring the KickBack up and under the RFA. The mounting
plate should be placed inside the two horizontal chainstays.
13
Make sure the charge indicator lights begin to blink green.
A full charge will take a few hours but you will be able to use
the battery with a partial charge by the time you are done
setting up your bike.
Please note: It is also possible to charge the battery while
it is installed on the bike, but for the initial assembly you
will need the extra room.
Also note that the battery will not supply power while it
is charging.
15
Place the KickBack so that the 2 ovalized holes on each side
line up with the bosses on the inside of the chain stay.
5